CVE-2026-89946

Published Sep 16, 2026

Description

In the Linux kernel, the following vulnerability has been resolved: ASoC: cs35l33: drain threaded IRQ before runtime suspend cs35l33_runtime_suspend() currently switches the codec into regcache_cache_only(true) and powers it down without first quiescing the threaded IRQ registered by devm_request_threaded_irq(). That leaves a window where cs35l33_irq_thread() can still run after suspend has closed off live register access. A running system can reach this during runtime PM while the driver still has critical fault IRQs unmasked. If the threaded handler runs in that window, it reads volatile INT_STATUS_1/2 after cache_only has been enabled, ignores the regmap_read() failures, and can still drive the AMP_SHORT_RLS, CAL_ERR_RLS, OTE_RLS, and OTW_RLS release paths. Use disable_irq() before entering cache_only/power-off so any in-flight threaded handler is drained and no new IRQ thread can run during the suspended state. Re-enable the IRQ only after runtime_resume() has restored live register access with regcache_sync(). Since probe only warns if devm_request_threaded_irq() fails, track whether the IRQ was actually installed before disabling or re-enabling it.

Is your site exposed to CVE-2026-89946?

Run a free security scan — no signup, results in seconds.

References

Frequently Asked Questions

What is CVE-2026-89946? +
In the Linux kernel, the following vulnerability has been resolved: ASoC: cs35l33: drain threaded IRQ before runtime suspend cs35l33_runtime_suspend() currently switches the codec into regcache_cache_only(true) and powers it down without first quiescing the threaded IRQ registered by devm_request_threaded_irq(). That leaves a window where cs35l33_irq_thread() can still run after suspend has closed off live register access. A running system can reach this during runtime PM while the driver still has critical fault IRQs unmasked. If the threaded handler runs in that window, it reads volatile INT_STATUS_1/2 after cache_only has been enabled, ignores the regmap_read() failures, and can still drive the AMP_SHORT_RLS, CAL_ERR_RLS, OTE_RLS, and OTW_RLS release paths. Use disable_irq() before entering cache_only/power-off so any in-flight threaded handler is drained and no new IRQ thread can run during the suspended state. Re-enable the IRQ only after runtime_resume() has restored live register access with regcache_sync(). Since probe only warns if devm_request_threaded_irq() fails, track whether the IRQ was actually installed before disabling or re-enabling it.
How do I check if I'm vulnerable to CVE-2026-89946? +
You can use Secably's free Website Scanner to check your website for known vulnerabilities. For infrastructure scanning, use the Port Scanner to identify exposed services that may be affected. Check the vendor advisories linked above for specific patch and version information.

Don't wait for an exploit

Scan your website for vulnerabilities like CVE-2026-89946 — free, no signup required.